- Home
- Firmware Update
Firmware Update
Instructions for
-
Slow Feeder Metal
-
Slow Feeder Ultra
Activate Firmware Update (OTA) Mode
-
How to enter OTA Mode for Slow Feeder Metal (Wave 1 & 2)
- Start with Dial Knob at 9. Turn knob down to 0, up to 9, down to 0, up to 9 and hold for 3s. Successfull connection is signaled by blinking LED.
-
How to enter OTA Mode for Slow Feeder Metal (Wave 3)
- 5 quick taps on power button (see video above). Successfull connection is signaled by blinking LED.
Access Slow Feeder Device
-
Connect to Slow Feeder WIFI: CremaLoop-XXXX
Note: Be sure to have downloaded new firmware bin file before connecting to the device.
-
Insert WIFI password: cremaloop2025
-
Access firmware update portal through an browser using either cremaloop.local or http://192.168.4.1
-
*** Important Note ***
Only install CremaLoop firmware modules onto the device. Any third party firmware could potentially harm the device and shall not be installed.
Firmware Versions (Slow Feeder Metal - Wave 1 & 2 Units)
-
V1.2 - Default Firmware for Slow Feeder Metal (Wave 1-2)
-
V1.3 - Update March 2026
Download Firmware: Added Low battery button LED warning (3 blinks upon startup), stronger startup kick for low dial numbers
Firmware Versions (Slow Feeder Metal Wave 3 and newer)
-
V2.0 - Default Firmware for Slow Feeder Metal (Wave 3 and newer)
-
V2.1 - Update March 2026
Download Firmware: Added Low battery button LED warning (3 blinks upon startup), stronger startup kick for low dial numbers
Firmware Versions (Slow Feeder Ultra - Wave 1 & 2)
-
V2.1 - Default Firmware for Slow Feeder Ultra (same as Slow Feeder Metal)